Aft view
And the area for the flush mounted bilge pump.
Sunday, March 28, 2010
More cockpit
Three more panels fitted today. Cut outs and fillings for the bilge pump on the front port panel. This is quite time consuming work, but I think it should be possible to start fitting the second floor layer tomorrow. I have considered painting the inside of the under seat compartments before fitting the tops, but if I'm able to tape in there I will be able to paint as well. Just a fast fairing before closing off I guess.
Aft view
And the area for the flush mounted bilge pump.
Aft view
And the area for the flush mounted bilge pump.
Subscribe to:
Post Comments (Atom)
2 comments:
I thought the same thing ('I can paint it later, so why do it now') - and regretted it.
Do all the painting you can while the compartiments are still open and easily accessible. It will save you a bit of time and a lot of painting in uncomfortable positions.
OK, Menno, I had success following your advice the last time, so will probably do it again:-)
Post a Comment