A few steps forward

The mast socket plate is very soon ready for mounting.  Shown with pre made flanges for centre web connection and main halyard hardware.

I glued in a tube for electrical wiring in the aft mast half.  Forgot to take a picture.

The trough tube for shroud fitting has been fitted and laminated on the inside.  I need to back fill foam, bevel edges and laminate the outside.

The flanges for aft half to centre web join have been trimmed and sanded.  This allowed me to test fit the centre web pieces and then the front half pieces.  The front pieces have been trimmed to fit each other in the joining area at spreader position.  The workshop is smaller than the mast and does not allow for good photo positions, here one shot trough the door and one along the mast.