Aft starboard beam mount taped in

I finally finished the aft beam mount moulds last week. Attached with self tapping screws at the lower end, and screws into the hull side at the gunwale.

Close up of mould.  Every corners between mould and hull or bulkhead to be filled with putty to nice round corners before taping.

All the fabric and UD reinforcements in place.  No way to vacuum this so it is a meticulous job to get everything nice and tight in every corner.

 

Detail of the upper folding strut bolt hole area with GRP doubler plate taped in.

The outside after removal of mould.